By Morgane Seraphine. Electrical Wiring. Publised at Monday, December 04th 2017, 00:59:18 AM. Electrical wire has very convenient ways of telling you what it is. Most of the coding is standard, so with a little study, you'll be able to figure out what you have to work with. Wiring does not come in a variety of colors to make it look good. No, there is a wire color coding system that applies to most wires in your home. Most importantly, you need to know that the black, red, blue, and yellow wires are hot and green is often the ground.
By Manon Marianne. Engine Wiring. Published at Wednesday, January 24th 2018, 08:08:33 AM. The internal combustion engine has seen a remarkable evolution over the past century. Before 1970 the evolution of engine design was driven by a quest for performance and an increase in octane in the fuel supply. Since then, however, the imperative was the need to meet new emissions and fuel economy regulations.
By Olivier Danielle. Engine Wiring. Published at Wednesday, January 24th 2018, 07:11:43 AM. All actuators needed to work in concert to heat the oil fast and keep the temperature steady. Opening the grill shutters or running the electric air fan consumes power. Controlling actuators in concert is a new way of addressing thermal management. While more complex, it enables the system to arrive at a steady temperature quicker and under all operating conditions, which extends the life of each thermal-control actuator, Laboe says.
By Morgane Seraphine. Electrical Wiring. Published at Wednesday, January 24th 2018, 06:20:12 AM. Install a cable clamp for each cable, as needed. Standard plastic electrical boxes do not have knockouts and contain internal cable clamps. Metal boxes may have internal clamps; if yours does not, install a locknut-type clamp for each cable. Insert the threaded end of the clamp through a knockout hole and secure the clamp inside the box with the nut. Tighten the nut with pliers.
By Olivier Danielle. Engine Wiring. Published at Wednesday, January 24th 2018, 02:24:31 AM. he combustion chamber in an engine is where the magic happens. It’s where fuel, air, pressure, and electricity come together to create the small explosion that moves the car’s pistons up and down, thus creating the power to move the vehicle. The combustion chamber is made up of the cylinder, piston, and cylinder head. The cylinder acts as the wall of the combustion chamber, the top of the piston acts as the floor of the combustion chamber, and the cylinder head serves as the ceiling of the combustion chamber.
By Manon Marianne. Engine Wiring. Published at Wednesday, January 24th 2018, 02:13:22 AM. Automakers are improving fuel economy by exploiting a new controls approach that uses the waste heat from vehicle engines. Currently, up to 65% of the heat energy produced in internal combustion engines, whether gasoline or diesel, is wasted. Typically, the powertrain or engine dissipates the heat by convection, where it is carried to the cooling circuit or lost out of the tailpipe in exhaust gases.
By Thibault Margaux. Engine Wiring. Published at Tuesday, January 23rd 2018, 16:16:00 PM. Automakers can improve fuel economy by selecting optimal coolant-circuit architectures, heat exchangers, and flow-control devices. The goal of this work was to warm up the drivetrain oils rapidly and run at a slightly higher temperature without additional hydraulic power. Kevin Laboe, who leads the Powertrain Thermal Management Team at Chrysler's Advanced Powertrain Group, Detroit, MI, and who led the simulation and testing teams, says the challenge was to distribute the heat in the most effective way.
By Marthe Mathilde. Engine Wiring. Published at Tuesday, January 23rd 2018, 13:57:19 PM. Internal combustion engine efficiency has historically been limited more by the state of technology than innovation. As an example, the potential of technologies such as gasoline direct injection were known and attempted in production more than 50 years ago, but direct injection has only become widely available in production within the last decade and now makes up approximately 38 percent of new light-duty vehicle sales. Another example is low-temperature combustion modes such as homogeneous charge compression ignition combustion—in which fuel and air are injected during the intake stroke and then compressed until the entire mixture reacts spontaneously—which were demonstrated in a laboratory more than 30 years ago but are still many years away from market introduction.
Keyinsp - Source Of All Wiring Diagram
Copyright © 2003 - 2018 Domain Media. All sponsored products, company names, brand names, trademarks and logos arethe property of their respective owners.